Siemens WXLM166AGB - WIRING FOR MOTOR

npritch · 29 Dec 2012

Just changed the carbons on the motor of my Siemens WXLM166AGB - putting it back together noticed a wire had become detached from the clip that goes into the back of the motor - eased the motor out again - 3 more fell out....
7 wires in all - all orange - no idea which one is which - HELP!!! Please...
Can't find any wiring diagrams - if I trace back to the PCB - possible to get them back in the right order - but don't know where to start.
Any advice would be appreciated.

npritch · 2 Jan 2013

It dawned on me that I was being a bit thick - I spotted the numbers on connectors both ends - matched the wires up using a tester to make sure all was OK. Replaced the carbons - put it all back together again - motor still not working. Bought a replacement motor - installed - switched on - loud popping from PCB. Wiring all fine - any bright ideas would be most welcome? Could it be that the original problem was a faulty PCB?

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

Siemens WXLM166AGB - WIRING FOR MOTOR

npritch

npritch

DIYnot Local

Similar threads