Hey I have installed a stainless steel kitchen sink the type with the clips to pull it tight to the unit. However a small section of the sink about 150mm is not pulled down tight to the unit like the rest of the sink. It has abit of bounce in it in this section. Anyway I can cure this without taking the sink out?
stainless steel kitchen sink not tight to unit
- Thread starter XanderHarris
- Start date
Sponsored Links
If it's a section that's between 2 clips then sounds like the sink lip is slightly out of shape and not level.
That could be part of the problem there is a place for a clip near by but I didnt have enough clips to put one there.
Sponsored Links
L
longdogs
Squirt some sealant under the area and weigh down with a heavy weight until set.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
