Tap stuck in cylinder head
- Thread starter Hotrod77
- Start date
Sponsored Links
Has it snapped off? Got a photo? You're in the US presumably?
- Joined
- 25 Jul 2022
- Messages
- 12,586
- Reaction score
- 984
- Country
Is the head on the car or on a workbench ?
Of all the forums that could answer that problem for someone in America, I think the last one I would think of signing up to for advice on that would be a U.K. based plumbers forum. Is this the return of you know who?
Sponsored Links
- Joined
- 17 Aug 2010
- Messages
- 3,272
- Reaction score
- 802
- Country
it could be a real plumbing tap, somehow got sucked through the carb - i'm sure american monster muscle trucks still use carburettors, no shortage of fuel, all actively encouraged by the new environmental minister - drill baby drill
- Joined
- 25 Jul 2022
- Messages
- 12,586
- Reaction score
- 984
- Country
How big do you think any carb is?
Well, a tap on the head, is always handy for water on the brain!
Most likely not, they are deliberately made very hard.
You might be able to grip and wind it out.
I think your first step should be to take the head off the engine.
Consider getting a replacement head which is likely to be cheaper and quicker.
Spark erosion is very good but I don't know what it would cost you.
How did the problem arise?
No reply was the answer......
I'd assumed this could be a brass coolant drain down tap, similar to those found in old British cylinder blocks?
If it's an HSS thread cutting tap then there's no chance.
John
I'd assumed this could be a brass coolant drain down tap, similar to those found in old British cylinder blocks?
If it's an HSS thread cutting tap then there's no chance.
John
Sponsored Links
