I was looking at some taps. It says in the document with it max pressure 3 bar. Do most taps suggest this? As most people will have more unless a pressure reducer is fit or there in a unvented hot water heater with the feeds balanced down to 3 bar after the composite valve on the feed to the cylinder. Thanks
Taps and pressures
- Thread starter XanderHarris
- Start date
Sponsored Links
- Joined
- 22 Jan 2007
- Messages
- 16,457
- Reaction score
- 2,324
- Country
Not sure about most, but it is common. I always fitted a PRV on new systems to rule out taps and shower issues.
Most people will just fit them without a prv. ?
- Joined
- 22 Jan 2007
- Messages
- 16,457
- Reaction score
- 2,324
- Country
I suspect most people won't even read the instructions...
Sponsored Links
Are you sure that most people will have over 3 bar? As it happens I have just measured the pressure in my house (North London suburbia) and it's a shade under 2.35 bar, which I understand is a quite normal reading.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Similar threads
