- Joined
- 1 Nov 2017
- Messages
- 4
- Reaction score
- 0
- Country
Hi all,
Hoping for a bit of advice.
I’ve set out the wall tiles in my small ensuite bathroom, measuring centre point horizontally and vertically.
Tiling horizontally doesn’t throw up any issues, however tiling top to bottom leaves me some options.
If I tile from the centre up and down (ie one tile either side of centre point) I am left with a full tile at the top (not top of the room) and approx 1/3 tile at the bottom.
I’ve read somewhere that if you’re not finishing at the ceiling then finishing on a full tile is best.
So my question is shall I keep the layout as it is - full tile at top finished with an edging strip, and 1/3 tile at bottom. Or adjust so even cuts top and bottom but with a cut tile finishing below ceiling height.
Hoping for a bit of advice.
I’ve set out the wall tiles in my small ensuite bathroom, measuring centre point horizontally and vertically.
Tiling horizontally doesn’t throw up any issues, however tiling top to bottom leaves me some options.
If I tile from the centre up and down (ie one tile either side of centre point) I am left with a full tile at the top (not top of the room) and approx 1/3 tile at the bottom.
I’ve read somewhere that if you’re not finishing at the ceiling then finishing on a full tile is best.
So my question is shall I keep the layout as it is - full tile at top finished with an edging strip, and 1/3 tile at bottom. Or adjust so even cuts top and bottom but with a cut tile finishing below ceiling height.