Hi, I have a PowerMax Complete wireless alarm system (D303983) and replaced the battery on one of the PIR's, a task which I have successfully completed numerous times over the years. On this occasion when I go to set the alarm, I get a message " Disarm not ready to arm, Alarm in memory" The Alarm Triangle in the front of the panel it not lit. Can anyone please advise on how I can reset this error message
Unable to arm a Visonic Powermax Alarm System
- Thread starter 802595353
- Start date
Sponsored Links
Check it’s been done correctly and do a walk test.
No reason why it should be any different unless you have done something different.
If it persists check event log for information/faults
No reason why it should be any different unless you have done something different.
If it persists check event log for information/faults
Lid on correctly, tamper switches closed.
Sponsored Links
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
