On you tube i have seen a video using a unika jig,they say to keep the bush against the edge nearest to you until you have fully cut through,then give one more full pass cut with the bush pushed against the edge furthest away from you other wise the mitre will not come out correct ,is this right and do you do this on all make of jigs.
Using a worktop jig
- Thread starter cannass
- Start date
Sponsored Links
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
