Hi,
We have recently had a water leak (sink overflow was not attached to the sink spigot).
This caused a lot of water to leak without noticing.
Most of this has dried out now with the help of a dehumidifier, however, I am a bit concerned about the MDF boards on the floor.
How much water content in these is too much?
I used a cheap moisture sensor.
Areas with no water show 0%
Area with water marks, but further away from the leak is around 10%
And under the sink where most of the water leaked is at 40%.
any advice would be appreciated.
We have recently had a water leak (sink overflow was not attached to the sink spigot).
This caused a lot of water to leak without noticing.
Most of this has dried out now with the help of a dehumidifier, however, I am a bit concerned about the MDF boards on the floor.
How much water content in these is too much?
I used a cheap moisture sensor.
Areas with no water show 0%
Area with water marks, but further away from the leak is around 10%
And under the sink where most of the water leaked is at 40%.
any advice would be appreciated.