Hotpoint Aquarius 1100 WD61 started jumping about, in middle of normal wash, very violently. Now it will not finish any programmes, dial does not advance automatically. Help!
wd61 tried to escape
- Thread starter freeflyfool
- Start date
Sponsored Links
B
breezer
i would guess it was in a rince cycle?
what were you washing, it is important
what were you washing, it is important
had just started a 60 degree wash programme. as soon as the drum started turning it started slamming into units onto either side. was washing two bath sheets. checked the weight it was fine, changed load to full load of tshirts and jeans. same again. now it fills with water and then the controller just clicks and doesnt move.breezer said:
Sponsored Links
B
breezer
I am only guessing (because i cant see it)
The tacho magenet may have come off , and or it has gone out of balance, as it shook so violently i would guess it has smahed itself to pieces (i have seen one do this before.)
Time for a hotpoint engineer
if it is over 5 years old it may be a write off.
you could un plug it, open the lid and look (see if the timer is damaged)
The tacho magenet may have come off , and or it has gone out of balance, as it shook so violently i would guess it has smahed itself to pieces (i have seen one do this before.)
Time for a hotpoint engineer
if it is over 5 years old it may be a write off.
you could un plug it, open the lid and look (see if the timer is damaged)
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
