Will a Methane boiler work on propane butane

[AquaHydroChem]

Hi
I have a boiler that runs on natural gas supplied from the national grid
Its for central heating and hot water
Its a Worchester 21i Junior
The cooper gas inlet pipe looks like 15mm and the bore of the hose on my gas bottles are 5/16"
My question is would my methane boiler work on propane butane with a restrictor/ regulator

Thanks
James

 

[45yearsagasman]

This is a wind up surely.Why would you want to do what you are asking and run a NG boiler off lpg?

 

[misterdubya]

Hi
I have a boiler that runs on natural gas supplied from the national grid
Its for central heating and hot water
Its a Worchester 21i Junior
The cooper gas inlet pipe looks like 15mm and the bore of the hose on my gas bottles are 5/16"
My question is would my methane boiler work on propane butane with a restrictor/ regulator

Thanks
James

Its a what boiler.
The what pipe?

Why not try and run it on used chip fat? Good stuff Ive heard.
Are you some kinda wally, or you just finished renovating a kitchen in Manchester?
Surely a wind up

Mr. W.

 

[AquaHydroChem]

This is a wind up surely.Why would you want to do what you are asking and run a NG boiler off lpg?

I never said LPG

and the bore of the hose on my gas bottles are 5/16"

Gas bottles draw the fluid out from the top of the bottle not the bottom so therefor its a gas not a liquid

Why not try and run it on used chip fat? Good stuff Ive heard.

Nope waste engine oil taken out of the waste oil bank at Morrisons supermarket

Change of plan
As you can see from the last pix I have removed the inlet pipe (after regulator) and the outlet pipe from the gas meter
I plan on joining the two together with a hose and some fittings
Therefore bypassing the meter
I pan on using hose as opposed to coper pipe for easy quick fitting
The question is what kind of fittings do I need to purchase
Question. What kind of thread are the on the compresion nuts on the inlet and out let
Maybe I could find a nipple for both ends
But they dont seem to sell tail/barb/hydraulic fitting in the plum center so do you think there is any thing ready made up in at the plum center that I can fit stright on

Thanks
James

 

[kevplumb]

bell end