Wire an alarm box help

[smithjames0]

I have a Accent alarm thats fully working, the only think left to connect is the bell box. The box is a gardiner technology the terminals are pictured below

The alarm brain has
Strobe +
Strobe -
T
A
D (Bell +)
B (Bell -)
SET


Am I right in thinking its wired like so

Brain to Bell box
Strobe + to Not connected
Strobe - to ?
T to Tamp return liked to Supply -
A to Tamp feed
D (Bell +) to Supply +
B (Bell -) to Bell -
SET ?

I have found this PDF but I don't know the model number of the bell box
http://www.soundandvisualsystems.co.../novagard range installation instructions.pdf



Thanks James

 

[sparkymarka]

you need to link tamp feed to ov in bell box and link 12v + to strobe + for a start. D PANEL to 12+ A PANEL to ov T PANEL to tamper return B PANEL to sw- and finally strobe - to strobe - if + 12v linked in bell box

 

[gtmsecuritysolutions]

Brain(or end station as its formally known) Bellbox
Strobe + <-------to-------> Strobe +
Strobe - <-------to-------> Strobe -
T <-------to-------> Tmp ret
A <-------to-------> Bell sw-
D (Bell +) <-------to-------> 12v +
B (Bell -) <-------to-------> 12v - <--put a link from
SET <--IGNORE here (12v-) to tmp feed


THE BELL LOOKS LIKE A NOVA OR NOVA2
ANY FURTHER QUESTIONS I'M HAPPY TO HELP![/u]