Worcester Digistat Timings

[darthpaul]

I have recently had a new worcester boiler installed together with a Worcester DT10 RF Digistat. The stat has preset programs for temps and times these temps take place. All of them start at 6.30am for morning heating. I cannot seem to find any settings that allow me to adjust the times of when the heating is on or off. Can anyone tell me if this is possible as I get up at 6am every morning and would prefer the heating on 15 mins before I am up so I dont freeze in the winter!

 

[oldman2]

Page 4 of the DT10RF Instruction manual, under "24hr operation" shows how to alter the event start/stop times and temps for each event.

Also the pre programmed setup "Program 3 (home worker)" page 7 already has a 6am start time if this is easier for you to use.

Remember though the manual states the DT10RF is a 24hr programmer so the start stop times set will be the same for all days of the week, no late start for weekends.

 

[darthpaul]

DOH! I have stared at the manual so often, not sure how I missed it. Thanks for that, glad I asked before the proper cold mornings set in. I know its only a 24 hour clock, I wish I had made my installer get the digistat optimiser now but will just have to live with it.

 

[oldman2]

Page 21 gives you the option of "inteligent delayed start" so if you want the house up to set temp for say 06:30am you can set this up to start at 05:30am and it will delay the start time based on set and actual temp to reach set temp by 06:30am.
This may produce some savings on milder mornings. Set this to on in the installer options.

 

[darthpaul]

Ah yes that would be a good feature! I like money saving to!