We have a zannusi TD62 Tumble dryer, with the overheat re-set on the back.
Latley it has started tripping out, no signs of over heat, wil re-set fine then carry on for 1/2 hr or so, then trip out again.
Today I stripped the machine down, cleaned all the air flows, vents etc, this hasnt made a differance.
There are no signs of over heating inside the machine, or any damage to the element.
So, do the overheat trips wear out, and eventually need repacing, or is there something else afoot??
Latley it has started tripping out, no signs of over heat, wil re-set fine then carry on for 1/2 hr or so, then trip out again.
Today I stripped the machine down, cleaned all the air flows, vents etc, this hasnt made a differance.
There are no signs of over heating inside the machine, or any damage to the element.
So, do the overheat trips wear out, and eventually need repacing, or is there something else afoot??
