ceiling

Here are some images of the kitchen ceiling where the oil boiler exits the room from above. I have chipped off the old plaster to reveal this. The height of the ceiling appears to have dropped around the pipe. Any advice most welcome.

Hi, I'm hoping for some advice for what to do about a couple of ceiling cracks. I'm a bit of a novice on this kind of thing, so thanks in advance. My bedroom on the top floor of a 1900 terraced house has two cracks which both originate at the corner of the ceiling and an interior wall. They run...

Hi all, I'm putting 10 x 2 joists in for a flat roof. The span is about 3m from wall plate into steel and then the same out of the other side of the steel to the fascia. The steel section is 254 tall so I've gone for 10x 2 to give a flat roof and a flush ceiling. Can anyone advise on the...

Hi, I have seen a few posts about similar online but was hoping hat somwone can settle my nerves as some places say, nothing to worry about. But other places suggest structual issues.. I have just bought a house 6 months ago and have recently taken off ceiling paper and repainted. Now parralel...

First time post here. There is a slight bulge in the corner of our living room ceiling where it meets the staircase. The bulge is dry and can be pushed upwards. It is a semi detached property which is around 30 year old. We've been in it now for about 6 months now and looks to have just been...

Hello there, can I please have some advice. I have a tiled bathroom to the ceiling all around. The ceiling is plasterboard, skimmed and painted. I have siliconed all around where the tiles and the ceiling meets. I have painted the ceiling before the tiles went up (might have been where it went...

I really hope someone may be able to help. My bathroom ceiling was a bit of a mess so I got some advice from a handyman friend about what I could do. He suggested sanding it down and getting off all the bits of flaking paint and bits of artex that were still on it. Then using pva followed by...

Hi, Has anyone got any advice in building a frame for ceiling lighting for something like in the photo attached. I initially built a small tray out of mdf as a sample to see what the finish would be like. Once it was primed and painted, I didn't think the finish looked that great updrywall...

I've got a rather large hole in the ceiling from some water damage. My first plan was to cut the plasterboard back to the nearest joist and then put up a new board to fill the gaps. What is the best way to cut the current plasterboard along the middle of the joist? Is it just a case of a...

Hi. I'm new to this forum and looking for some guidance on a subject that has made me worried sick.... A few years back my wife and I bought a mid 1930's house that needed a fair amount of work. We had a back of house extension done for a new kitchen/diner, however to save money my father in...

I'm planning to lower my kitchen ceiling as one end is at a different level to the other by about an inch and to allow me to install spotlights. The room is 18 feet by 10 feet and I was planning to build the frame from 3x2" softwood spaced in a 400mm grid approx 7" below the existing ceiling...

Forgive me if this turns out to be a stupid or pointless post.. About 18 months ago we had the bathroom decorated. My Dad and brother did it. We had some foul artex that my dad and brother removed with a sander (yes, I know..) It was SO messy. I remember it was absolutely EVERYWHERE like a...

Me and my fiancé have just bought a house and we're thinking about some DIY improvements. A friend of ours suggested putting up coving in the lounge but I started looking into it and I'm just so confused. I've watched a million videos on how to actually put it up and that. But how do I know...

Hello, I wasn't sure how to categorise this question so feel free to move it into more suitable sub-forum. I'm looking for some advice. I'd like to route some (7-8) CAT6 Ethernet cables from downstairs living room (router) to the upstairs bedrooms. Most of the cables will be used for...

Hi DIYnot, Wonder if I could call on your expertise. I have 1973 house with flatroof with asphalt on tonge-in-groove construction. Under this is an 11" high cavity with no ventilation between rafters. There is 20mm polystyrene insulation resting on plasterboard with the obligatory artex finish...

Hi everyone. First post here. I will be stripping the paper off the ceilings on a flat I have just bought. Though to me it looks like some sort of artex? I know this stuff could contain amounts of asbestos which is my main concern. So first off is one of the bedrooms. It's thick wallpaper though...

I have looked around the forum but I can't find a similar case to mine. I caused a gate valve to leak in the airing cupboard. A small amount of water leaked before I could get the valve repaired. The water flowed to an old crack in the ceiling where it dripped through the artex causing a...

hi Two of my three bathroom ceiling bulbs went off, I thought I'd better get them fix before the last one die too. I had a look at them they got no clicks or anything like that, all they got is a sealed ring and a glass (photo attached) Can someone shed some light for me please , how to open...

Hi We recently purchased a detached property and it has a flat roofed utility that backs onto the garage. Its not a massive area but my father in law painted the ceiling in that room and poked a hole through it about the size of a tennis ball very easily. It would seem that area is rotten...

Hi all, Another year, another set of projects planned. I have a house that was built in 1989 and first sold in 1990. It has artex in every bloody room on the ceilings. My plan (over time) is to have completely smooth ceilings in every room. Upon reading about the removal of artex, I came...