floor

Hey there We purchased and installed engineered oak flooring as part of our living room renovation a bit over 12 months ago. The flooring was installed over a screeded wet UFH system using Bona R848 Flexible wood adhesive. The screed was given plenty of time to dry before we installed the...

I am somewhat out of my depth with a house renovation and would massively appreciate some advice regarding the kitchen floor... There has been subsidence at some point in the house and the concrete kitchen floor was uneven to the tune of around 50mm from high end to low end. I ripped off the...

Hi, I've been a plumber (not heating engineer) for 9 years now and finally bought my first home. As my first project, I decided to install a warm water UFH system. I've decided on Mapei Latexplan Trade for the screed which will be aprox 20mm thick. The data sheet states max 11mm per coat...

Hi, I moved in a a rented flat in a newly constructed building 2 weeks ago. There is a laminate flooring in the flat. In the utility room, there is an interrupter that reads "Extraction". This interrupted was set to off and the landlord didn't mention it when I moved in, I didn't even know it...

I have the option to buy a herringbone wood floor I have seen in two thickness options 10mm or 14mm (about £150 more). Which would be better? Most likely I will be doing a floating fit, tongue and groove, as it has 2 underlays (duralay and sound proof vinyl).

The ply substrate is for a click vinyl surface. the cls frame will be sat on rubber pads or low level decking pedestals on rubber pads (on a membrane) I was thinking of using a stud type support framework so that ply edges have landings along their full length? So does the usual 400mm joist...

I recently realized I can hear water sloshing around when I put pressure (IE walking) over the flooring near where the front porch meets the main house. House was built in 2015, floor is concrete base with layer of plywood then Amtico (decent quality sealed flooring) glued on top. The house...

Im in the process of preparing to lay a concrete floor in my newly built diy conservatory. I have a double french doors opening out into the conservatory. the doors have a upvc sill on them and just below that is the DPC for the house. My question is: can I raise the concrete conservatory floor...

Hello, What's the best way to cover the gap between the floor and the riser of the stairs, in particular, the radiused section of the stair risers. Some kind of timber moulding would be ideal, however, I am at a loss how to neatly cover the radiused section. Thankyou in advanced

Hi, I'm looking at installing some laminate in the living room of a newly purchased house that was built in the 60s. When I took up the carpet there is a strong must smell and large cracks and debris near an external wall (see pics). The floor is concrete with black tiles (vinyl i guess?) How...

I fitted solid wood floors about 5 years ago. There’s quite a noticeable grain in the wood, which looked nice when new, but over time it has been a magnet for dust (if I’d known this would happen I would probably have used different flooring, but hey ho). Also a couple of times I’ve been doing...

I am looking to fit real wood flooring in two rooms with a door frame in the middle. I don't particularly want to have a joining strip. The boards will go along the width of the door and I am concerned that I might not be able to get the click-lock boards together once they are fitted into the...

Hi all, We're currently renovating a Victorian house and are struggling a little with the kitchen floor situation. As we are in a tough spot financially we cannot afford to get any trades in at the moment so please no suggestions on that or i'll cry. As you can see from the picture half of...

I have an understair cupboard which was made by a carpenter which need to be improved as the horizontal board as threshold just look horrible ( see Photos). Is there any way to strongly fix the 4x2 stud to the floor in order to remove the 4x1 board? I can replace the 4x2 with a longer one which...

Looking to re carpet one of our bedrooms, which has a pronounced ridge running the length of it, around 2ft from the nearest wall. Seems this is because the breeze block wall of the room below is higher (especially with joist hangers) than the joists that the chipboard rests on either side...

Hi all, We've had an extension built with 600mm x 600mm floor tiles laid through from the hall into the extension. In the hall, the tiles are laid on a suspended wooden floor with underfloor heating between the joists, chipboard across the joists and Ditra matting. However, the tiles have...

Hi. Quick question: I have rigid insulation upstands around the concrete slab in my extension, and am using self-levelling compound on it before laying engineered wood. Do I trim the insulation and level over it (creating a thin cold bridge to the masonry/bifold frame) or level first and trim...

Not long before we have a carpet fitted (with underlay) in our front bedroom once plastering and decorating completed - normal floorboards with a small void (where you can see some dust, debris and wiring) between this room and the lounge underneath. Does anyone know if you need to 'fill' gaps...

Hi, I'm getting to the end of a renovation and the concrete floor screed has been laid. This is in a rear extension to the kitchen and also a new extension at the front. There is a gap of about 3 inches between the top of the floor and the DPC level, both at the front door and at the back...

Hi, first post here. We bought a home just two weeks before the pandemic kicked off... about 2 months later we noticed the living room floor can wobble. We viewed the house three times and visited for measurements many times after, we didn’t notice the floor shift once! There was nothing in the...