gap

Hi I've got a curved bay at the front of the house with upvc window that is in 5 parts, between each part is a vertical tube shaped section to allow the window to curve around the bay. I've uploaded 2 photos to show this. Where each section of window meets the vertical tube section there is some...

Hello, Hopefully a straightforward question (and hopefully I'm posting this in the right place), I have little to no DIY skills, but I'm working on it! We have an old Garage/Outbuilding that has been in a state of disrepair since long before we bought the house. We finally have a bit of time...

Just in the process of buying a “new” house. House was built 10 yrs ago and kitchen replaced just over 6 months ago. It’s got built in fridge, built in freezer, built in oven, built in hob and even a built in microwave but no built in dishwasher. There is a cupboard, that I could remove...

For anyone that has installed composite decking... What expansion gaps do you leave and does it depend on what temperature you are installing them in on that day?

I've installed this new floor and used acoustic underlay (mutemat-3) and plywood below the wooden floor. The floorboards weren't changed and are quite old and crooked (in retrospect I should have changed them but wasn't guided to do so). Also, perimeter strip (a foamy strip) has been installed...

We have recently installed some new sash windows and the reveal lining has been attached. I have not ordered or placed the architrave around the window but the intention is to do so. Currently it was foamed but there is some deep areas, is it ok to use Gyproc filler or better to NHL 3.5 then...

Hi all, I moved into my house last year. All of the windows upstairs have huge gaps in them, some of them I can actually fit a whole finger down the hinge side and can see daylight. These windows were only installed in 2011. As per advice I’ve seen I have bought some new hinges. Just replaced a...

Hi, I am building a half stud wall that I will be covering with 12mm ply and then plasterboard, then adding skirting once it’s had a skim. I was wondering if I need to leave a gap at the bottom of either covering like you would on a masonry wall? I would think not to leave a gap for the ply, but...

Hi all. I'm planning on internally insulating the front of our house and have just stripped back the wallpaper and am taking the UPVC surrounds off the double glazing to fill the voids. There is a massive void above the double glazing in the main bedroom (8 inches between glazing and brick)...

What tolerance for packing behind the door lining should I include in a new blockwork doorway? How much of a gap do you leave at each side of the door liner? Thanks, Dain

Please see attached pictures. This window seems to have dropped a little and there is a gap at top which lets in a lot of road noise & draught. The window itself opens & closes perfectly. Windows are in place about 13 years. Any thoughts on what I need to adjust to seal it up. Many thanks.

Hi all, I have a 600 base unit and a 800 and 900 base corner unit. When fitted they will have a 32mm gap either side this includes the corner molding. Can anyone give some advice on how best to finish this neatly.

Looking to repaint the garage door so thought I might as well do the woodwork at the same time and looking for a product to fill any gaps between the brick and frame. My first thought was silicone but then wondered if a putty of some sorts would be better? Regards

Just had the original Welsh slate removed, felt and new battens. The original slate and additional reclaimed slates laid. Called the roofer back as the eaves didn't look right and a gap is now evident behind barge boards. Gaps under slates on eaves. Gap behind fascia board (that's an old...

We live in a rented flat and have recently started having problems with carpet moths in one of the rooms. There is 100% fitted wool carpet everywhere, so perfect for them. When trying to find the nest we noticed what looked like rice grains near the fitted/built-in cupboard/dresser and pulled up...

Hi everyone, I'm clueless about this but after our last shower developed a big leak (it was 15 years old) I'm having a new one installed and the plumber put the shower tray in yesterday, cutting it in under the plasterboard, but leaving about a 2cm gap between the top of the tray and the bottom...

Hi all, I've just laid a reclaimed maple parquet/wood block floor and I'm in the process of sourcing filler and finish. After reading a lot my preference would be to go for Lecol 7500 and Blanchon hardwax oil. However I'm struggling to get hold of both locally in Bristol (in time for hiring the...

Hi Folks, there is a pretty large gap in our garage door which lets a lot of cold air into garage. Can this be improved in any way? Picture here: https://1drv.ms/i/s!AvxDFgUHUgNCxFFWrt2bKXIebhqD Thanks folks.

Hi Folks, during winter our bathroom can be quite cold and doesn't really hold much heat. I have the bathroom window sealed up and loft insulation in place. Recently I have noticed a draught coming out of a gap between the tiles and our bath. The bathroom is above our garage. I went down to the...

Hi all, I am preparing to screed my concrete subfloor, having pulled out the old one which was uneven and full of redundant pipework. I am the top-floor flat and there is a riser for the soil pipe, mains water feed etc running inside the flats. There is a gap between the structural concrete...