garden room

So the time has come to finally start my Garden Office build project. I've posted some info here - https://www.diynot.com/diy/threads/garden-office-project.523670/, but the TL;DR is that I'm building a 4.27m x 4.27m garden office using SIPS panels at the bottom of my garden. As this is...

Hi all, I'm in the process of building a garden room. It's a lean-to structure in the corner of the garden against the boundary wall. There is a wall at the rear face and against the right hand side: My sketch is pretty rudimentary, but hopefully you can see a basic studwork structure in...

Hey all... I'm in the process of designing a new garden office to replace an existing T&G Log cabin that's had it's time... The office footprint is going to be 4.8m wide x 4.2m deep, and will come in under the 2.5m height for permitted development. I'm intending to add a small kitchenette...

I've built a garden office last year and is well insulated, breathable membrane, air gap then cladding for breathable aspects. On the warm side i.e. before internal walls is vapour barrier which I research as the best for stopping moisture in winter, and effectively creating a sealed box. The...

Hi Ive search in lots of places but cant find a definitive answer to reassure me. I have some concerns about the base of the new garden room I am having built by some builders. It seems a bit cowboyish to me. The new room sits where the old shed and patio is. So the wooden base half sits on a...

About to wrap my timber framed garden office with the breathable membrane and battens but am unsure how the edge detail is finished with an EPDM roof. The cold roof rafters end flush with the stud wall rather than any overhang. If I go by the limited diagrams seen so far (see attached), then...

some advice needed. Before I ask advice I will be getting any wiring signed off and completed by a qualified electrician before connecting to the house mains. I just want to save some time / money by running the cables around the stud frame of my garden office and want some basic advice if...

Hi there. I've had some very helpful advice from this forum recently, but need some more if possible. Just wanted to confirm the insulation specs. The plan is currently; Floor 75mm PIR insulation laid directly on concrete with glued battens spanning front to back as a fix for scaffold...

Hi, I need some advice if possible on the best type of membrane for a timber framed structure for a garden office. I was going to have the stud wall, membrane, battens, then ply cladding sealed with Osmo oil. Parts of the cladding might be open joint cladding with vertical battens, but am...

I'm building a 4.8m x 2.8m (ideally) garden room and need some advice on the base / subfloor and possibility of overhang on the floor joists. As you can see in the image, I've got a concrete slab (not insulated) that I was going to sit the 3x2 treated joists directly on with DPC underneath each...

I'm thinking about materials to clad my garden room in and was going for ply panels or battens which I want to stain/paint black. Ideally with ply I'd like to see some wood grain through it, but am confused about the different types of ply. Marine ply is too expensive and possibly overkill, WBP...

Hi there, Firstly I'm new to this forum, so apologies if I've not posted in the correct place etc. Any advice on the following would be much appreciated: I'm building a garden office 4.8w x 2.4d x 2.5h. The concrete base is already done (about 80mm on top of hardcore, mot and dpm, no sand...

Hi I'm looking at taking down my existing concrete outbuilding and building a timber framed office/room in its place. There is already all concrete base for the existing building. Would I need to raise the timber base/floor off of the concrete base? I have read about putting pressure treated...

Hi folks, Happy new year to you all! It's that time of year where thoughts turn to DIY projects for the coming year so for my first post on this forum I wanted to outline my plans for a self-built insulated garden room (all the rage at the moment I gather from the number of posts on here) and...

Hello, Im just drawing up a garden room, 5m x 5m. but with 3.5m x 5m insulated plastered room. The other a storage. Im looking at SIPS, has anyone done this in the south east, Portsmouth area. With any tips? or recommendations.