gas

  1. O

    Installing marble mantle and surround before new gas fire is fitted

    Hello all Need some advice, I have builders that are going to install a marble fireplace surround and a separate unconnected gas safe chap who is installing a focal point Eastleigh high efficiency gas fire. The fire surround is this one...
  2. J

    gas apps

    hi there , new to the forum , any 1 out there using any gas apps to run there busines ,
  3. A

    Repurposing disused gas pipe

    I am in the process of moving some mains cold water pipework in my house which will make it pass through a concrete floor. There is a copper gas pipe which was disconnected last year that runs through the concrete. On the face of it, this may seem like a silly question, but is there any reason...
  4. T

    Is my boiler illegal and can't be serviced?

    Hi, We bought a new Barratt Home in 2007 and haven't modified the boiler or its boxing since then however today an engineer has refused to service it saying its boxing and exposed pipe is illegal (boxing above boiler and pipe to side - photo attached). The boiler has been serviced each year...
  5. S

    Installing Nest in New Build

    Hi, I have just moved in to a new build home and am thinking about replacing the thermostats with Nest 3rd Gen. The property is Gas and has instant hot water. The house is zoned, upstairs and downstairs with a thermostat in each zone. Boiler = Ideal Logic Combi c30 Programmer = Danfoss FP975...
  6. A

    Balanced Flue / Sealed Gas Fire using existing chimney

    Hello all, I currently am trying to improve the thermal efficiency and comfort level in our our 1920's end terrace. The main issue in our living room is the draught up the chimney. We currently have a high power output open gas fire. However this is useless as the draught up the chimney sucks...
  7. A

    Installer threatening to deregister my boiler

    I have been trying to get hold of the building regulations compliance certificate of the boiler installer. I also have a problem in that the installation benchmark form has not been filled out. The boiler was installed from the previous house owner in 2014. After tracking down the installer they...
  8. H

    opened gas pipe by mistake - what action needed?

    I had a dripping water pipe. It was in a cramped space, so I needed to temporarily remove an adjacent pipe to adjust it. The next-door pipe looked exactly the same - however, when I loosened the isolator-valve connector, it was obvious it was a gas pipe, not a water pipe. I quickly tightened...
  9. eveares

    How many gas fires support conventional hard wired thermostats?

    I don't need a gas fire as I have a lovely log burner, but was just wondering how many gas fires on the market support conventional hard wired thermostats as in the type you use with central heating systems? All of the gas fires I have had a previous places I have lived have been very basic...
  10. G

    New Boiler - Change Of Gas Pipe Required?

    I am currently in the process of having a new Greenstar CDi Classic boiler fitted and would be grateful if someone could help me with technical question. The distance between the gas meter and my boiler (in my kitchen) is between 11 and 12 meters. The gas supply also feeds my oven hob. Will my...
  11. eveares

    Gas patio heater - Are they efficient?

    I am looking at a 12Kw FireFly gas patio heater from Primrose, and just wondering how long will they run for on average based on a Full 13KG Propane bottle with a 12Kw burner on it's highest setting? How does the efficiency compare electric patio heaters? Reagrds: Elliott.
  12. B

    Use of flexible copper pipe to connect gas hob

    My son has just brought a flat with a recently refurbished kitchen and I noticed that the gas hob has been connected using one of those short lengths of bendy (corrugated ) copper pipes between the hob connection and a gas isolation valve. The installation looks quite neat and professional, with...
  13. cwhaley

    Gas pipe...

    Before we bought our new place we were renting. We had asked the landlord permission to drill above the fireplace to hang a mirror; it was his old house and we were on good terms with him so no problem. Well, that's what I thought. Measured up where we needed to put the two screws. It was a...
  14. S

    Pub converted to flats - gas/water for neighbours run through mine!

    Hi. New member here. I bought a flat last year, in a converted pub on a very long lease. The developer went bust and the conversion was finished by contractors working for the new freeholders - a firm of solicitors. The development began in 2015. The main pub building has been split into three...
  15. K

    Location of gas boiler flue (with a twist)

    I've got a prime case of Gas Safe pointing to Building Regs and Building Regs pointing to Gas Safe. And a gas fitter (and me) stuck in the middle. I have a domestic combi boiler, fitted donkey's years ago. The flue went out through our wall that is alongside the neighbour's garden. It vents...
  16. D

    IDEAL MINI C24 INTERMITTENTLY ON/OFF (VIDEO)

    Hi everyone i realise this is an old thread but I have a similar issue....my combo goes on and off every few seconds....i have got 1.5 water pressure and I have already taken off the heat exchanger and cleaned it...when I set the boiler to just DHW nothing at all happens....when i set it...
  17. choppachimp

    redirect an exiting flue?

    have a dated gas boiler, which heats the central heating AND hot water (works fine BTW). Unfortunately the flue exits approx. waist height, straight out into the path of my workshop door. Sending hot air (not a bad thing when its cold) and fumes (not a good thing at all!) when it kicks in early...
  18. A

    Main Medway Super

    Hi , Can someone help me with my main Medway super. The problem is that I had a water leak which I've fixed by putting a new push rod O ring. But now I'm having another problem with a small gas leak just under the burner where the pin is , it lights up when the pilot is on and causes a small...
  19. J

    Ideal ICOS HE24 gas Boiler - sometimes makes a loud noise when stops heating

    Our Ideal ICOS HE24 gas boiler sometimes (about once a day) makes a loud noise when it stops heating, and it sounds mechanical, as in a bang. I'm guessing it's either the fan or the gas valve - probably the fan - perhaps a bad bearing? Are there any known problems of this nature with this...
  20. P

    v4600c gas valve not opening

    My gas valve failed completely so I replaced it (after only 34 years!) with a 'seller-refurbished' one. That also wouldn't open so the seller sent me another - and that didn't open either! So I bought a new one (old stock) and fitted it - and that doesn't open either! I also gave it a tap when...
Back
Top