insulation

  1. btg202

    Advice on solid wall insulation

    Hi, We've got a narrow corridor outside out bathroom, and a rear bedroom as part of an extension which is solid wall and (a) gets really cold, and (2) suffers from damp. The damp problem has been resolved recently by having a PIV system installed, but I was wondering if anyone had any advice...
  2. L

    Insulating loft

    Hi everyone, our three bed Edwardian is very cold. The upstairs heats with heating but then gets cold quickly once turned off, whilst the downstairs gets warmer (only to about 16 / 17 degrees Celsius currently) and then dips. looking to insulate. We have cavity walls but will not insulate here...
  3. D

    Upgrading A 1930’s House’s Energy Rating

    Most people when when upgrading a 1930’s house they think changing the boiler and replacing windows will keep them warmer and save costs on heating but that’s really only going to help so far people don’t realise the cold air under their feet and the pipes under their floor are likely not...
  4. P

    Advice needed on loft insulation and boarding please!

    Post closed
  5. J

    Insulating PVC panels

    Hi all, I have recently purchased a holiday chalet that has PVC external walls under the windows. Think very wide PVC door with a solid panel bottom halves. I am wanting to build a timber framed false wall on the inside as I am having all the internal walls reskimmed. The false wall will be...
  6. Buenaventura Durruti

    Want to insulate under rafters with Multifoil - no membrane under tiles...

    Hi all, I have recently bought a house (1920s/30s) and want to insulate my loft. Currently there is about 100mm of fiberglass between the joists and floored with chipboard. I really need the loft for storage so rather than add extra glass wool I want to use multifoil under the rafters - it looks...
  7. P

    Insulating a solid blockwork outbuilding

    Hi All. I am constructing an outbuilding office, its not to live in and doesnt need to comply with building regulations. I plan to insulate the floor using 50mm celotex. The walls are solid 6 inch concrete blocks. I am looking for the cheapest way to insulate it. Any ideas please, explanation...
  8. J

    Loft condensation and insulation - help please!

    Hi I'd be really grateful for help/advice - I'm panicking a bit! As a bit of background.... I am looking to replace the current loft insulation (fibreglass/rockwool), laid on the loft floor. This has been prompted by a potential problem of condensation on internal walls/ceilings; in our second...
  9. H

    garage suspended slab venting and garage insulation

    Good morning. I am looking at making my attached garage more cofortable and with less humidity, it currently runs around 80%. Garage is 5m x 5m, one wall is pretty mucy all taken up with a double garage door, one wall is the link to the house so I have 2 external walls at 90 Deg to each other...
  10. S

    Retrofitting membrane and insulation into old roof

    Hi All, Apologies if this is roof construction 101. I recently bought an old house and the garage has zero roof insulation. The roof consists of the timber frames, battens, nails & tiles. I would like to add a membrane and insulation without dismantling or redoing any of the existing roof...
  11. C

    Air vent in suspended timber floor

    Hello, We have a suspended timber floor, and that suspended timber floor contains an air grill (see picture attached). The grill attaches to a plastic ventilation shaft below the floor which is about 20cm long. It's a bit odd, given that most guidance on ventilating suspended timber floors...
  12. _DCG_

    Insulation - Cost vs. Benefit - Walls or flat roof

    Hi, We live in a semi detached house built in 1949 which has a double storey side extension that was built in 1996 to add a garage and additional reception room on the ground floor, and a bedroom and bathroom upstairs. The bedroom and bathroom are above the garage, however the reception room is...
  13. Sscott

    Creating Vents in Summer House Walls

    Hi all Just looking for some advice. I have built a summer house which is cladded with Hardie Plank followed by a breathable membrane. The frame is built with 4x2 and I'm using Rockwall at 75mm for the insulation. I fixed the cladding directly against the membrane and frame so I want to create...
  14. Battor

    Thin acoustic layer

    Hi, I am renovating a terraced London house. The space is a premium and I cannot take inches. I can't add 10cm and I just want a little extra sound proofing on party walls. I looked at thin Mass loaded vinyl (MLV), which comes in 2-4mm or Tecsound (2.5mm for 25.2dB) But I would need to paint...
  15. K

    100mm insulation equivalent

    im finding reclaimed 1.2 m x 2.4 m x 100mm insulation boards online for £29. it's too expensive. Does anyone know a supplier or an equivalent technology to kingspan that is less. Has anyone tried blowing their own closed cell (waterproof) foam and do you know where I could get it. still...
  16. ahearsum

    Is this Vermiculite and is it dangerous?

    I'm remodelling my first floor bathroom and lifted the chipboard floor to find a load of small stones. An internet search suggested it my be Vermiculite and that it might not be that good for me if I breath in the dust. Does anyone have any experience or knowledge of this and if it is dangerous...
  17. SS-ProjectBuild

    XPS insulation below DPC in trench...

    Hi Guys, Any issues with placing 50mm xps insulation slabs externally in the trench below dpc/ground level before backfill? To help with insulating the building? Please see pics.
  18. J

    Hot to installe multifoil TLX silver if 38x50mm are not available?

    I have to install the TLX silver multifoil which specified to have 38mm thick batten but impossible to source on my area with only available in 25x50mm. have you had any issues like that? How can this be solved? The 25mm is to thin and not enough air gap is left to let the multifoil work. Thanks
  19. M

    T&E wiring, behind insulated stud walls

    After a bit of initial advice, please. Decided to internally insulate a solid brick outbuilding as it's freezing in winter... in the process will be needing to move and add more electrical sockets etc, going to use said building for general craft/diy type projects. I had intended to build...
  20. eveares

    Plastic bit on pull cord switches is for insulation/saftey reasons?

    Just started watching the following video, where it is claimed that the plastic bit in the string of pull cord switches is for insulation purposes and thus is a safety device. I can understand this if true, although is new news to me. Any truth to this, have you heard this before, and is there...
Back
Top