socket

  1. D

    Converting single socket to triple socket, with 1 earth wire

    Hello, I have just moved into a house and in our living room there seems to only be 2 single sockets. Ones fine but the other is near where out home entertainment system (TV, audio, lights etc.) Will go. We started with extension cables but before we knew it, we had extension on extension which...
  2. eveares

    Socket to close to Sink?

    Just wondering what the regulations were for how close a socket could be to a sink in the year 2000. The photo below is from a kitchen at a commercial office building that was likley built around the year 2000, the edge of the socket is only about 100mm-150mm away from the edge of the sink ...
  3. R

    Adding a plug socket - round a corner

    Hi I have a long rectangular room with 3 sides being external walls, the other being an internal one. It's a modern house so the internal wall is just a stud partition. The room has 4 double sockets all on the same ring, and all mounted on the external walls. I would like to add an additional...
  4. N

    Correct Wiring Setup with 2 Master Sockets?

    Afternoon all. I am stuck at a crossroads with how to further proceed with a non existent broadband connection setup by talktalk. We had an engineer come to the house to setup all the wiring etc to get everything working for us and was told within a few hours we would have an Internet...
  5. ianbatten

    Wiring behind insulated plasterboard?

    Hello, I am looking to dot & dab some 25mm thermal plasterboard on the external solid wall in my lounge, after stripping back the plaster back to the brick. I'm looking to have 2 sockets on this wall. In terms of wiring, can this just run behind the thermal plasterboard if chased out of the...
  6. K

    MK Logic plus socket terminal screws, where to get?

    I am looking for terminal screws for MK logic plus double switched wall sockets. Had a fairly extensive look online and cannot find them. Have even phoned MK and they say they are not available. They are a screw; of course they are available. Screw measures approx m4.5 and is 9mm long. Anyone...
  7. eveares

    What do the regs say about sockets fed from portable UPS being RCD Protected?

    Just wondering what BS7671 says about fixed sockets being RCD protected when being fed from a portable UPS (i.e. removable rack type UPS) when the the UPS is operating on battery mode and the Line & Neutral conductors are isolated from Earth. (Effectively a Isolated Terra based earthing system.)...
  8. eveares

    Plug to Socket Extension with no Earth!

    Just seen a video from a fairly big UK based YouTuber, who went to Home Base to get a some bits to make up an extension lead socket. Shame he picked the 2 core 0.75mm² flex. Not sure if he know's he has not earthed it or not or the safety implications of what he has done? Video Below, see...
  9. M

    Help with an accident!!

    Hi, I've trawled various forums and can't seem to find an answer to this so hoping someone can help. This afternoon I was just about finished trimming hedges in the front garden when stupidly I cut through the cable with the trimmers. Luckily no injuries, however the power as you'd expect went...
  10. G

    Just moved - BT wiring question

    Hopefully someone can point me in the right direction. I've just moved into a small flat. I'm due to have the phone/broadband installed next week. Apparently the service will just be 'activated' so no engineer will call. I am trying to make sense of the existing BT sockets. There is a double...
  11. D

    Storge Heaters replaced with plug sockets :)

    Hi, I've looked at a few threads but would like advice on my particular set up. I want to replace a load of storage heaters (5) with plug sockets. Please can you look at the photo below and recommend how to do this? Thanks! :) https://drive.google.com/open?id=0BwS53MI0_NV0TTBXdjUxNmY0eWs
  12. eveares

    My stupid mistake while abroad - Tooth brush charger + European socket!

    Went to Spain a couple of weeks ago to visit a friend. I have just realised while I was out there that I plugged the charger for my Braun electric tooth brush directly into the EU type socket. No 1A fuse, No isolation transformer, nothing protecting the charger other than the 20 Amp MCB along...
  13. A

    Gap around socket - Please help me

    Hi I have just had my kitchen tiled and found that there are gaps around two sockets. The tiler said that the socket was incorrectly installed and that there is nothing he can do. It looks terrible and is really obvious when you walk into the kitchen. Please help me as I have no idea what to...
  14. S

    mains sockets with 2 USB ports delivering 2.1A to both ports (not shared) ?

    Hi I'm thinking of getting some mains sockets with built in USB ports, along the lines of these: http://www.screwfix.com/p/mk-13a-2-gang-double-pole-switched-socket-2-1a-usb-charger-white/3905g I haven't purchased any yet though as I can't find any that can deliver 2.1A from both usb ports at...
  15. M

    chrome light fitting light switch do u need to earth front plate

    Hi I've been replacing my white sockets and switches to chrome I've done a few of the double sockets, however when attempting the light switches the switches are earthed to the back box but do I need to do the front plate aswell!? there is a designated earth connection on the front plate but I...
  16. eveares

    Earth-less Sockets!!!

    So the front room of my house had all the plaster ripped off a few months back due to damp problems :rolleyes: and is due to be re-plastered next year. :) Well today I went to remove the wire terminating at a junction box from the only socket in the room and discovered the CPC of the cable was...
  17. eveares

    Plugging plug in backwards in a trailing socket.

    Anyone care to repeat this, guess my trailing socket and/or plug must be defective. Not that much force was applied. Socket has got PMS 9128 written on it, plug has PMS 9248 written on it if any help for identifying the brands.
Back
Top