thermostat

Hello! We moved to a new house in the summer and have only needed to use the central heating the the past couple of weeks, but it seems to go on and off at strange times of the day and night. As far as we can see all we have is a WR1 unit next to the boiler and a T4RF unit in the hallway which...

Hi all, I spent the past few days trawling these forums to find the answer with no luck so hoping someone can help. Just got a new gas combi system, so all new boiler, rads, pipes etc. The thermostat and an 'always on' radiator are in the hall. This rad is reaching the stat temp so quickly...

I am hoping someone can help with my query. I am replacing my existing Centaurplus c27 controller and Honeywell thermostat with the Drayton wiser 1 channel system to control my vallient combi boiler (no separate hot water). My first query is in regards to the thermostat. I understand I should...

Hi All, I’m having some building work done and plan to swap my Honeywell ST699 to a nest thermostat following the work. One question I have is regarding the room stat I have in my lounge. Is this needed following the nest installation? If I was to disconnect the room stat now before I install...

Hello all I’ve just moved into a new house and I have bought a Nest smart thermostat to install. I’d like to try and install this myself with your help in order to save myself a bit of cash. There is an existing wireless Salus stat already connected to the combi boiler. See photos. Please can...

Hi all, Just bought my first home, and been redecorating. Got it looking spiffy now. The British Gas UP2 programmer (in the kitchen) and RS2 thermostat (in the living room) are huge eyesores though. And I am fairly sure the thermostat is broken. Ideally, I would like a digital thermostat in...

Hi, first post, so I hope I have the correct forum I am planning to replace my Towerstat RS thermostat which is in a bad location in my hallway with a Salus 310RF. This is in order to allow us to have the thermostat in the living room rather than the hallway. The Towerstat uses two only wires...

My Salus rt500rf programable thermostat is acting bonkers. Had it working fine for 6 months, now its going crazy. It has been used on its factory settings, 22 degrees, manual and no programed on/off times. In the early hours of the morning, around 3am/4am it ignores the set temp on the unit and...

I have a Worcester Bosch HE Plus 35 working with a TR2 thermostat. We have noticed that the heating never seems to fire up when we 'feel' it should. So I thought I would check out whats happening. I set the TR2 to 20 degrees and then looked at the Info display on the boiler which says that...

Hi, Over the past couple of days I have noticed there seems to be an issue with my central heating. The boiler appears to be working normally, it is firing up heating up the hot water but it isn't consistently firing up for the central heating. I think the issue is something to do with the...

Bought a house recently and I am renovating it at the moment. It has a gloworm 24cxi combi boiler with a british gas on/off clock and a separate wired thermostat, im looking to upgrade it to a wireless stat. Does anyone know if a honeywell DT9E like this will work with this boiler: The...

I have a faulty obsolete (20yr old) oven thermostat incorporating a separate oven fan/light switch tab. Can't find a 'universal' replacement. If I fit a standard 2 tab thermostat, and connect the fan and light, they will switch on and off with the element which is not ideal. I have a Stoves...

hi, I’ve got a thermal store water heater running on two immersion heaters, one boost and one on eco7 circuit. The eco7 one seems to have started working only intermittently. Occasionally I’ll get up and find that the water is running cool when it should have been heated overnight. Usually it’s...

Let me first list the set-up we have: Vaillant ecoTec Plus 637 system boiler Zilmet unvented hot water cylinder with external expansion vessel 1 zone valve for Central Heating 1 zone valve for hot water cylinder 1 Grundfos 15-50/60 circulation pump (on flow pipe from boiler) 16 radiators...

Hi I have a precious boiler it seems, a Baxi Solo 3 PF 30. When calling for heat or hot water it will run fine for 15 minutes, and then it starts to cycle on and off at one minute intervals until the control stops calling. If I unclip the thermostat from the pipe it will run fine without...

Good evening all and apologies for what i can imagine is the millionth nest query but after trawling through the forum i couldnt find what i need.i have a brand new baxi duo tec 28.it has no manual timer, programmer or thermostat so i have bought a 3rd gen Nest thermostat. I am confused as to...

I have a wall mounted Gazco Studio 2 fire with a balanced flue. The remote has a thermostat feature whereby you can set the required temperature and the remote control automatically adjusts the fire to suit. Recently, if I have the fire in the thermostat mode, it will just completely cut out...

The boiler's circuit board is unlabelled, but based on the current configuration hope someone can help check my deductions/proposal... At the moment: Programmer/Timer (Sunvic Select 107XL) N/L connected to its own fused spur power supply. 1/COM is connected with a Brown/Live cable to the...

Hi there, I would really appreciate some help if possible. I have an Ideal Instinct boiler and a Salus RT510TX thermostat. Last night the Salus thermostat stopped connecting with the receiver- the red light on the receiver is flashing red, the heating no longer comes on and it doesn't respond to...

Hi, I have two danfoss tp4000 in my house. I want to replace these with smarter versions of it. Preferably something where I can just replace the thermostat and make it all smart with the ability to control it remotely. I have combi boiler so i think investing in a nest and or hive/tado is...