toilet

Hi all, Hoping for some advice. I'm a self builder and I am about to put in the plumbing for 2 ensuites and a main bathroom. Each has a toilet and it's the waste pipe to soil pipe plumbing that I need a little help with. 1 toilet will go up against an outside wall so I'm OK with that one as I...

Hi, Trying to find a solution for our en suite. Most spigots centre at 180mm high on all the toilets I can find. We are installing an en suite in a confined space. The problem we have is that the exit through the wall for the toilet waste has the steel running by it. Thus to avoid it, the...

Hey! I live in the middle floor of a 3 storey apartment building. The flat above has a leak. I’ve been in to investigate, and from what I can see the seal from the nut and bolt screw holding the cistern to the toilet has warped. Could anyone recommend what type of fixtures I’d be searching...

I have an inlet valve that is allowing some water in even when the float is raised. I wanted to check the washer - presumably diaphragm, but after taking off the cap, I'm unsure how to dismantle the valve. Any tips? The inlet came with a NUCA C211 valve. The other option is to remove/replace...

The toilet flush button (pictured with the flush system) has broken but I can’t find a matching replacement or a replacement flush system that matches the one I have. It has a bayonet fitting (pictured) which makes it extremely easy to remove/replace, hence I’m loathed to have to remove the...

I'm replacing my old toilet and cistern. The flooring is P5 moisture resistant chipboard. The new toilet pan is not as high as the old one and needs to be raised by about 25mm. I'm proposing to screw a piece of P5 chipboard (22mm thick) to the floor and fix the pan on top of it. As an...

Hi all We've been experiencing an intermittent smell from our downstairs toilet for the last few months. We've tried replacing the pan connector and have had a CCTV inspection on the drain, but the problem persists. Last week I removed the toilet again and disconnected the sink trap. Both have...

The question says it all really. I have just put in a new toilet. Everything seems fine, but it does have a constant trickle into the bowl. It's hardly noticible... but I noticed and now can't unsee it. Is there a simple fix for this? Is it something to do with the float? Everything is brand new.

I plan to fit my first toilet in the next week or so and just studying the steps involved before I jump in. I've noticed in a number of videos that some form of lubrication is often recommended for the interface between the toilet spigot and pan connector to ensure a proper fit. Back in my...

Hello Started to notice a few of these large flies downstairs and today there are half a dozen all in the downstairs toilet mostly by the waste pipe. Not seen this before but assume there is something around there causing this.. Ideas how best to deal with this? Cheers

Hi, I have just moved into a house with a toilet that has a dual flush valve, the type that is screwed into the cistern lid with a plunger on the bottom. It seems to sit too low on the cistern and when I push it it only half flushes the toilet. If I remove it and then push the top of the flush...

I'm considering buying a WC that has the spigot 215mm set back from the cistern edge, but my soil pipe comes through the floor, next to the wall. Therefore I will require a standard 90-deg pan connector (e.g. McAlpine CON8) + extension piece (e.g. McAlpine CON-EXT). Will this in any way impact...

Having spent ages looking across the market, the Rak Summit seemed to the best-fit for my requirement. Thing is, I checked on TrustPilot and Rak get absolutely slated, with many complaining about flushing issues and poor quality ceramics; not specifically related to the Summit though i.e. many...

Hi, We have had this toilet installed, but there is skirting board around the room. I was expecting the toilet to sit flush against the wall, but I didn't even think to ask about the skirting board. Is cutting the skirting board where the toilet will be considered best practice? Is there a...

Hi I’m renovating my new bathroom and wondering which brand should I go for? In your experience which flush technology is better? Do they splash when flush? Quiet? Easy to broke / leaking? / Ceramic quality What’s your opinion? I don’t like that some toilet require multiple flush, or even...

So I am hoping someone can help me with this? We are currently renting our home and the landlord wants to sell it, so we are looking at problems the house has and trying to figure costs etc… to see if it’s worth our time and money. So… the toilet in the bathroom is on a stud wall with the...

So I am hoping someone can help me with this? We are currently renting our home and the landlord wants to sell it, so we are looking at problems the house has and trying to figure costs etc… to see if it’s worth our time and money. So… the toilet in the bathroom is on a stud wall with the...

I am replacing a traditional toilet with a Grohe frame and I need to replace the existing waste connection (see pic below) with the one that comes with the Grohe frame. The connector goes down into the concrete floor and I have no visibility of where it goes/ how it connects. If I just yank it...

Right so I recently moved into my council flat. It has a wet room. Which has a shower, sink and a bog (toilet). If water from the sink goes on the floor or if you **** on the floor next to the toilet, it will flow past the shower and towards the door… Which obviously will cause issues. i stuck...

I watched seven videos and read numerous instructions and none tell me what I need to know. Have removed both metal push buttons to reveal a central retaining screw between the two plungers which the buttons operate. All the instructions say to unscrew this screw to allow the lid to be removed...