wiser

Can I fit the Wiser Radiator Thermostats to these TRV valves? I think Wiser require M30 1.5mm valves and I suspect I have Comap M28 1.5mm type. I think I have Westherm 6 TRV's, but I am not sure. Do I need the following adapters? I hope not given the extra cost...

Hi All, Due to a quick, good deal purchase I'm now the proud owner of a Wiser Kit 2. I currently have a strange set up (but all Drayton) - all controls, boiler, hot water tank etc... are in the airing cupboard upstairs. The original set up was a single Drayton hot water and C/H controller...

Just in case anyone has some ideas to point me in the right direction! The system: Vaillant EcoTec 418 system boiler with unvented tank. S-plan (2 zone, CH and HW). Grundfos 3-speed pump (set to 2). Recently added smart valves (Drayton Wiser) to 5 out of 9 rads, so boiler load is reduced (all...

Hi I've just bought a Drayton wiser to replace my Lifestyle LP241. The old controller had a universal backplate and the central heating is controlled by a wall thermostat. Can people just help me make sure I get the new wiring correct? Want to disconnect the thermostat as suggested in the...

Hi I've just bought a Drayton wiser to replace my Lifestyle LP241. The old controller had a universal backplate and the central heating is controlled by a wall thermostat. Can people just help me make sure I get the new wiring correct? Want to disconnect the thermostat as suggested in the...

Hi All, I would like to replace a Honeywell room thermostat with a Drayton Wiser (I'll also be replacing the radiator valves later). Can I just confirm that: N & L stay the same 2nd L to A loop in the Honeywell should now be L to 1 in the Drayton 2 in the Drayton stays empty B in the Honeywell...

Hi I have a cpl of question, but I'm also posting as this might help others trying to get Drayton Wiser to work properly with Vaillant (or other boilers). Setup: ecotec plus 418, S plan, installing Drayton Wiser smart controls (currently 3 rad valves). Problem: the boiler is short-cycling...

Hello, I am wondering if I could find some help on this forum with regards to adding the Drayton Wiser to my system. (Boiler is a Glow.Worm Flexicom24cx) I have taken some photos of the steps I have taken to try and follow the instructions from Drayton, and hopefully someone can point out the...

I am hoping someone can help with my query. I am replacing my existing Centaurplus c27 controller and Honeywell thermostat with the Drayton wiser 1 channel system to control my vallient combi boiler (no separate hot water). My first query is in regards to the thermostat. I understand I should...

I am trying to install a new Drayton HeatHub (1zone), just trying to work out wiring as I am replacing Honeywell T40 thermostat. Images attached of exisiting wiring and new HeatHub wiring diagram. Cheers Jon 10D3C2B1-6E84-4DE4-988F-3E8C1B45CB6B by JonnyGo posted 20 Jan 2018 at 4:34 PM...

Fairly complicated one this, but would appreciate any input if anyone has any thoughts. Currently, have a old, Baxi Boston boiler, with pumped CH, gravity Hot Water in our house. Works great, added a NEST to it that made it pretty easy to control and make the house warm when we want it. Like...