Has anyone any experience with fitting 2 cylinder stats to a buffer vessel to increase the volume of water being measured?
I'm installing a buffer vessel as part of my UFH installation to work with an external oil boiler, however trying to work out if this is worth the extra effort over installing a single thermostat on the cylinder which has an adjustable hysteresis. The thermostat that I'm planing on using is the EDBS model from EPH Controls.
At present I have approximately 245m worth of pipe laid on the first floor and expect to have a similar amount on the ground floor when I get around to installing that. I'm looking at installing a 100L buffer vessel.
I'm installing a buffer vessel as part of my UFH installation to work with an external oil boiler, however trying to work out if this is worth the extra effort over installing a single thermostat on the cylinder which has an adjustable hysteresis. The thermostat that I'm planing on using is the EDBS model from EPH Controls.
At present I have approximately 245m worth of pipe laid on the first floor and expect to have a similar amount on the ground floor when I get around to installing that. I'm looking at installing a 100L buffer vessel.