Accenta g3 alarm won’t set but battery is new,

[Wullie1967]

Accenta g3 alarm won’t set but battery is new, so when I disconnect it all put it back together the alarm goes off then I put my code in and alarm stops but after that I try set it again the keyboard beeps every number you press which is normal but it won’t set and the TA light is flashing so then I press the reset button and TA light just goes a steady red light and then the keyboard doesn’t respond to any button press, when I walk into each room the alarm sensors pick me up as they go red, now here is the thing I removed a wall in my house so I didn’t need the sensor in that room anymore so the sensor got took away and wires put in the wall so could this be the problem and how do I sort it if it is would I need to go to circuit board and disconnect they wires that’s linked to that sensor, thanks in advance

 

[Bigsosij]

You will need to identify the wiring for the zone that has been removed and disconnect it from the global tamper circuit. Assuming this is the only tamper fault currently present then the system should then reset.

 

[Wullie1967]

According to my wall we moved in dinning room it says zone 4 on my keypad so I went into my pannel and moved the 2 wires going into zone 4 they where green and white wires but nothing changed