- Joined
- 20 Dec 2009
- Messages
- 11
- Reaction score
- 0
- Country
Hi I have a felted flat small canopy above my front door its slightly bigger than the door width.
When there is heavy rain the rain pools a bit on top but sometimes but rarely it drips slowly over the front edge.
I was wondering if there is an easy solution for it , small bore drainage channel would be cheap as its not big and easy to fit
At a guess i would say the canopy its less than 2m long and less than 1 m wide.
If so would it be acceptable to drain down on the right hand side where there is a down wall next to front door 90 degrees to the property direct onto my Resin Bound Suds compliant drive?
There are no drains nearby
There would be minimal amounts of water as the canopy is small and the existing drive takes all the rain anyway ?
Any thoughts
When there is heavy rain the rain pools a bit on top but sometimes but rarely it drips slowly over the front edge.
I was wondering if there is an easy solution for it , small bore drainage channel would be cheap as its not big and easy to fit
At a guess i would say the canopy its less than 2m long and less than 1 m wide.
If so would it be acceptable to drain down on the right hand side where there is a down wall next to front door 90 degrees to the property direct onto my Resin Bound Suds compliant drive?
There are no drains nearby
There would be minimal amounts of water as the canopy is small and the existing drive takes all the rain anyway ?
Any thoughts