Antipollution fault ?

Joined
26 Jun 2004
Messages
64,921
Reaction score
4,898
Location
London
Country
United Kingdom
My petrol 1974cc Peugeot 307cc 2004 year goes through long cycles of showing an antipollution fault.

Typically fault on for about seven weeks and then off for five weeks.

Can anyone suggest what might be causing the fault to be displayed and then to disappear?

There is no obvious change to the engine performance between either condition!
 
Sponsored Links
This often happens when the catalytic converter is getting unhappy......the fault clears after a good hot run but often comes back in time.
Make sure the lamp is off at MOT time!
John
 
The "off" condition occurred a few days before I needed to take it for an MOT.

So how to make my cat happy?

The off condition shows no obvious connection with long motorway journeys.
 
Keep the cat sweet by giving the car a good run as often as you can and it will look after itself.
John
 
Sponsored Links
You really need to get a fault code reader plugged in and read the fault codes, so that you know which bit of the "anti pollution system" is being troublesome. Could be a lambda sensor too - or an airflow meter. There are various potions you can put in your fuel tank to clean cats, or various sprays to clean airflow meters (sometimes called "MAF"s). Maybe even try a few tankfuls of premium fuel that's supposed to "clean your engine"? When did it last have a set of plugs?
 
Like most of the Peugeots of similar years the headlights are not at all bright.

The low and high bulbs are all 55W halogen bulbs.

There are some 100W LED bulbs being sold from China but they do not get very good reviews.

But if I did try some would I be risking any damage to the wiring? Or could I assume that it could handle 9 Amps?

Any comments?
 
There are some 100W LED bulbs being sold from China
They will not be 100W or anything like it.
100W equivalent perhaps, meaning they are probably around 20W or so.
Or more likely it's just a nonsense claim, and the actual wattage and light output could be literally anything.

In any case they will probably be unsuitable for use in enclosures designed for halogen lamps, and result in the typical blare-o-light effect where their only purpose is to blind other drivers.
 
Back
Top