imperialist through and through, as a model engineer I prefer imperial
measurements.
We gave the world the standards of measurement, good enough for engineers long gone, good enough for me, still here.
Do you find imperial measurements easier? I was taught in metric-only so find decimal points easier than natural fractions, but some years ago was involved with some US equipment where all the measurements were in pounds, feet and inches... we generally ended up doing all the design in imperial but converting to metric at the end to allow stress calculations etc.
I did build equipment with Whitworth screw threads back at uni... I could have used metric but the lab technician had a few sets of Whitworth taps and dies, plus the lathe could cut Whitworth so I chose it as a nod to the man himself!