Which of these two is the preferred method the push down clicker waste for a bath or the type were you turn the overflow. Thanks
Bath waste clicker or turn overflow type
- Thread starter tomsim
- Start date
Sponsored Links
Clicker for me......had a couple of the others where the cable snapped it's support and they were awful to get to.
Can't beat the good old plug though!
John
Can't beat the good old plug though!
John
My order of preference:
1. Old fashioned plug on a chain. Needs a bath or overflow fitted with the anchor point.
2. Pop waste operated by rod behind taps. Usually specific to a set of taps / waste fitting.
3. Overflow / cable operated. Fine as long as you operate it a couple of times a week, otherwise cable rusts and seizes.
4. Flip over plug. Permanently in place but depends on O ring seal.
5. Click clack waste. Never known one to last more than a matter of months before failing.
1. Old fashioned plug on a chain. Needs a bath or overflow fitted with the anchor point.
2. Pop waste operated by rod behind taps. Usually specific to a set of taps / waste fitting.
3. Overflow / cable operated. Fine as long as you operate it a couple of times a week, otherwise cable rusts and seizes.
4. Flip over plug. Permanently in place but depends on O ring seal.
5. Click clack waste. Never known one to last more than a matter of months before failing.
Sponsored Links
Forget clicker wastes, I replace hundreds of them. Cable operated every time.
Andy
Andy
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local