Hotpoint WF 540 Fault code display 3&4 flashing

[mapco]

Hi I have a Hotpoint WF 540 that has stopped working, it has lights 3 & 4 Flashing combined with the on button.

I have turned it off at the mains to attempt a reset but no luck. The Mc starts fills then stop with the lights flashing.
Any ideas would be most grateful Of the fault code meanings I may be able to work something out from that.

Thanks in anticipation

 

[rocks1]

f01 light 4, motor triac
f02 light 3 motor, jammed/ tacho
f03 lights 3&4 Ntc fault
f04 light 2. pressure sw stuck on empty
f05 lights 2&4, pressure sw stuck on full
f06 lights 2&3, N/A?
f07 lights 2&3&4 heater relay
f08 light 1. heater relay
f09 lights 1&4 eprom/setup error
f10 lights 1&3, pressure switch not sensing
f11 lights 1&3&4, pump/draining error
f12 lights 1&2, communication error
f13 lights 1&2&4, dryer ntc/ fan motor
f14 lights 1&2&3, dryer heater
f15 lights 1&2&3&4, dryer heater relay
f16 N/A
f17 light 4, door lock
f18 light 3 comms error (3 phase motor) power board

f1 and f17 share the same light