PIR Zone not to be used (scantronic 9751)

[Europlex]

Link 0v to terminal marked as TR (Tamper Return )

The panel will then think that a bell is fitted and this is the Tamper Return, the one that is causing your problem.

The Global Tamper also needs a link, of wire

 

[benny2009]

Link 0v to terminal marked as TR (Tamper Return )

The panel will then think that a bell is fitted and this is the Tamper Return, the one that is causing your problem.

The Global Tamper also needs a link, of wire

Oh well,of course, why did I not think of the 0v link!!! It was obvious, I'd disconnected the bells....inexperience speaking!
you've just saved me a lot of time & headscratching!! I really appreciate your help mate.
Many Thanks to you & Alarm on this site...
Cheers!!

 

[Europlex]

No probs, even WE don't know everything, well, perhaps we doooooooo

 

[Alarm]

Boaster...................

 

[benny2009]

No probs, even WE don't know everything, well, perhaps we doooooooo [/quote

LOL! at least you chaps have the heart to share it!!

I still have one more issue regarding the SD1+ connection to the panel.
I've ONLY got Kepads connected at the moment, but if I try powering up with the molex connector connected (for plug on Comm.) which is connected to SD1+, system wont power up.
If I disconnect the molex, the system powers up.
The power to the molex (last 2 pins)is also disconnected.

I've wired the SD1+ as follows:
Brown output on molex - trigger A on Dialler (Fire)
Orange - Trigger B (PA)
Yellow - trigger C (Burglar)
Red - +12V
Black - 0v
Tamper - to separate zone with 2k2 resistor & programmed as 24HR.
A& B on dialler hardwired to telephone socket.

Could Something within this connection is preventing power up???
regards

 

[Alarm]

It looks correct.
I`d double check connections.

 

[benny2009]

It looks correct.
I`d double check connections.

Thanks alarm, I'LL do that.
cheers