Plasterboarding Walls

[Alson]

Hello guys,

My walls have Wattle/Laths.

I am considering just to remove the plaster only and nail/screw plasterboard over the Wattle/Laths.

Thin skim plaster on.

I am of the opinion that, leaving the Wattle/Laths will give a more solid backing.

Thanks for any advice.

 

[Wayners]

You can if you want or remove.
Fit cross timbers will make it more solid. I don't think laths add much strength.
You can also board wall with wood ply sheets then plasterboard over as this makes fitting stuff to walls easy and adds strength.

 

[Alson]

Thank you for advice. I have removed the laths.

I tried to attach file, but could not.

 

[Wayners]

Take a picture on a phone.
Just tap the symbol next to the camera symbol here.
Select picture and it will upload. If that was what you wanted to know

 

[Alson]

OK. Will do.

I have ordered 5.5 plywood as backing for the plasterboard. These will go horizontal. Plasterboard vertical.

I plan to use only a few screws to hold the plywood, initially, since longer screws will go through the plasterboard, plywood, and then the studs.

Any recommendations, please?.

Thank you.

 

[ree]

OP,
From the info in your opening post there was no need to remove anything - plaster laths provide excellent strength to a partition.
Perhaps all you needed to do was skim over the existing surface.

In your last post:
You dont need to use a plywood backing for plasterboard. Standard plasterboard is 12.5mm.
Plasterboard over studding is fixed horizontally to the studs.

 

[Alson]

Ok.
I already paid for the plywood and planned to lay them horizontal, plasterboard vertical.
However, you suggest lay plasterboard horizontal.
Since they are all 8 x 4s, they cannot take the same run.
So, plywood will need to be vertical ?.

 

[ree]

OP,
Read what I said: "You dont need to use plywood backing for plasterboard".

 

[foxhole]

Thin ply is more likely to cause problems if it is allowed to bow between studs where it will prevent plasterboard fixing flat to studs .