Polycarb canopy project

[kjacko]

Not yet, almost pushed the button yesterday but got distracted.
This is what i've got on my list (all for 10mm polycarb)

• 2 x plastic F section 2m
• 6 x Timber supported snapdown glazing bar 2m (aluminium base with plastic snapdown top)
  
• 3 x bags of fixing buttons (10pk)
• 4 x sheet enclosure 2.1m
• 1 x roll of breather tape 10m
• 7 x 915mm x 2m 10mm polycarb twinwall clear sheets
• 4 x low modulus silicone
• 8 x snapdown end cap

£260 inc vat and delivery. Best price i've found anywhere on the net really.

 

[Mw Roofline]

Not yet, almost pushed the button yesterday but got distracted.
This is what i've got on my list (all for 10mm polycarb)

• 2 x plastic F section 2m
• 6 x Timber supported snapdown glazing bar 2m (aluminium base with plastic snapdown top)
  
• 3 x bags of fixing buttons (10pk)
• 4 x sheet enclosure 2.1m
• 1 x roll of breather tape 10m
• 7 x 915mm x 2m 10mm polycarb twinwall clear sheets
• 4 x low modulus silicone
• 8 x snapdown end cap

£260 inc vat and delivery. Best price i've found anywhere on the net really.

I'll ask our suppliers for you on Monday, they deliver all over the uk. If cheaper you can ring them direct.
I thought the poly was gonna be 1.5 metres long and you've got 2m sheets there.
What's the last line for? Normally you get 1x end cap with each bar in the pack.
Clear or opal poly?

 

[kjacko]

thanks mate, that would be most appreciated.
sorry, the the brief changed slightly.
It's now 7m x 1700 (but 2m sheets was the closest without paying the expense of cut to size)
Regarding the end caps i wasn't sure. One quote i got specifically saif end caps sold separately, so assume that was the case everywhere.

Thanks again bud

 

[Mw Roofline]

£236.32 inc vat and delivery

It's Brett martin poly and it's already cut to 1700 and they tape it up so no need to buy a roll of tape.
I'll leave it with you to communicate direct with them as don't check on here much so their number is 0121 311 2666 and your quote number is 8493. Hope I've helped cheers.

 

[Umy786]

Hi Mw, sorry to jump in on your thread kjacko, but Mw would you mind providing a bit of help & advice on my project I posted here

//www.diynot.com/diy/threads/polycarbonate-lean-to-roof.451830/

Thank you

 

[kjacko]

Hey, no worries, go nuts
Mw, thanks so much for your advice and the heads up about Brett Martin.
I'll give them a call when i'm ready (things have been delayed a littel due to unforseen issues)