Power Shower on cold mains feed

I don't see that it's too late, since (a) I responded to your post almost immediately, and (b) it may yet help the OP (or other readers).

The NewTeam Jetstream seemed to be the only one anybody knew anything about.
Er, they're just cheap sh*te.
 
Sponsored Links
Thanks for the help. Bought a Trevi Boost on the net, arrived on Friday, looks good, fixed head. Will be fitting it over the next couple of weeks. Simplifies greatly the work I would have needed to do to fit a pumped system, so hopefully it will work well.

Great site, keep it going.

JA
 
johnny - don't forget the following:

1. Read the instructions carefully;
2. Install full bore single check valves;
3. Tune the setting of the cylinder stat (and/or immersion stat).
 
softus,

Will read the instructions and I have the graphs re cylinder temp and pressures, so should be ok with that. Not sure on the check valves, what needs to be done with these?

JA
 
Sponsored Links
Er, you install them. One on the hot and one on the cold.
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top