Pyronix door sensor. Exit, final exit timer and detection doesn't work. Tried relearning.

[kyrusdemnati]

Hey guys
I have an issue
My door sensor is not working, battery is all fine


Front door input type of 10
fx area er

Input areas is set to AB

INPUT AREA - any
Chime - follow
Omittable - no
Confirm group 00


Change timers (A)

Entry 10 seconds
Exit time 10 seconds


When I do engineering tests
It doesn't recognise or trigger the tone for front door either




I have two zones A AND B

B is night mode, so I would want the alarm to be triggered if front door opens

 

[sparkymarka]

Is it new ? Does the light come on the sensor when you open the door ? ( better to see if it’s dark )

 

[sparkymarka]

Post picture of contact fitted on the door

 

[kyrusdemnati]

Thanks guys appreciate your help

 

[kyrusdemnati]

Ignore the ring one.

The light doesn't come on when door is open
I know I should see a blue light

 

[kyrusdemnati]

When I remove the screw
The system does recognise a tamper and alarm goes off ,

 

[kyrusdemnati]

I've unpaired it for now, as I get a test failed error when saving nvm data

And I don't want the alarm to randomly go off

 

[sparkymarka]

What that at the side of the enforcer MC1 ? looks like another wireless device with the magnet near the Reed switch of the MC1

 

[sparkymarka]

As below

 

[kyrusdemnati]

Yes that a ring alarm
Door sensor
I have that system aswell ...

 

[Bigsosij]

I think he may be suggesting that the magnet from that may be keeping the switch closed..

 

[secureiam]

It’s easy enough to test, remove the ring magnet that’s on the frame.

Then retest.

 

[kyrusdemnati]

Ah you are right . I see the blue light come on immediately when I open door

Let me relearn and add the device

Not sure if I have the timed exit set up correctly but will report back

 

[kyrusdemnati]

What does it mean if the blue and yellow light remain on, it stays on and I can't configure it as it's says tamper

 

[kyrusdemnati]

Light has gone off . But it keeps going off when trying to set and panel has the hazard. Light indicating tamper

I've currently set it to 0 unused

But when I try and set alarm

It says exit via final exit and just gives a tone not a timed countdown and nothing more .

I've tried changing the door sensor to final exit which is 07 and the other ex/er 09/10 and it's still the same

There is definitely a timer set
But it's not recognising the door sensor
It diagnostics I believe it showing as a T
WHERE other devices are ccccc