small size of screw in new sockets

Sponsored Links
TBH I can't remember if they were captive ones backed out too far, or regular ones done up too tight.
 
The FCU's are fine, you just need to gently press against the fuseholder, whilst screwing in the holder retaining screw.

That is indeed my technique, but I've come across a fair few where, despite pressing and subsequently, in my frustration, pushing hard on the fuse carrier while tightening the screw, it just will not sit flush with the rest of the accessory. If you then try to compensate by doing the screw a little tighter, all that happens is the screw starts to go off an an angle and the whole thing looks a complete mess.
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top