Can you describe again exactly where you are measuring these voltages ?
100V across immersion - no hot water
- Thread starter PHILatHOME
- Start date
Sponsored Links
Immersion cable connects to an isolating switch in the airing cupboard, the feed for this is chased down a wall to 'somewhere'.
I turn the switch off (open) and measure 100V across the L & N, at the same time I measure 230V between L and E and 150 between N & E.
My thoughts, if this circuit was all correct would be that I should read 230V across L and N with an open circuit and should read 0V between N & E. I don't understand why I am getting either of these readings L/N or N/E as they don't make sense unless maybe there is an earth fault (but just dont know!!!).
I turn the switch off (open) and measure 100V across the L & N, at the same time I measure 230V between L and E and 150 between N & E.
My thoughts, if this circuit was all correct would be that I should read 230V across L and N with an open circuit and should read 0V between N & E. I don't understand why I am getting either of these readings L/N or N/E as they don't make sense unless maybe there is an earth fault (but just dont know!!!).
- Joined
- 17 Aug 2010
- Messages
- 2,866
- Reaction score
- 497
- Country
So neutral is broken or badly connected somewhere.
Sponsored Links
So you are measuring on the load side of the double pole switch, yes ?
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
