1st time routing advice please

Morning all.

Well im pleased to report that I'm getting the chance to practice of loads of old off cuts before I take it to my actual project.

As I learn more about routing I'm getting more used to the terms. Aside from t trim I'm also looking at cutting a channel on the face of the board to slide some hardboard into.

For that I take it I need a straight bit? But I notice some are fluted, is this better/worse or a different type of bit altogether?

Thanks as always!
 
Sponsored Links

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top