Cleaning CH system using Sentinel X800

Yes I did look and clean the magnet, which didn't seem to be very magnetic to me, it must be working, as quite a lot of sludge around it
I gave it a good clean, so hopefully, it'll still be working well.
Still on high at the moment. One hour gone, I'll leave it running for another couple of hours, then flush it out again
I have already run the hot water through the Exchaner plate for 30mins, doesn't appear to be blocked (yet :D)
 
Last edited:
Sponsored Links
Sorry, meant to say....
As it was pretty clear when I drained it, do you think I'll get away with just filling straight away with sentinal 100?
after I've drained the X800?
 
Last edited:
I did say AFTER I've drained the X800
I realise I have to drain that all out, just wondered if just draining it all out will be OK to fill with X100 as the system was clean on the first drain off..
It's such a pain getting to the drain cocks in the lounge and Kitchen (down feeds)
 
Last edited:
Sponsored Links
Well, I rinsed twice and look's like all the 800 is out, refilled with Sentinal 100, and back to normal.
Thanks for taking the time to help me, everyone.(y)
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top