He is unable to make any changes to A circuit without bringing THAT CIRCUIT up to current regs. If he is only working on one circuit he may be able to transfer it to the second box.Which work can't he do without upgrading it?
and it continues to sayBS 7671:2008 Requirements for Electrical Installations was issued on 1st January 2008 and is intended to come into effect on 1st July 2008. Installations designed after 30st June 2008 are to comply with BS 7671:2008.
The main point is it refers to "design" so that if the design is not changed, there is no need to upgrade. However often new editions clarify, this then results in a problem, as it can point out that the regulations have been miss read. And this is surprisingly easy to do. One full stop, read as a comma can completely alter what has been said, so there have been cases like the over sleeving of green/yellow cables where people have simply miss read the regulations.The Regulations apply to the design. erection and verification of electrical installations, also additions and alterations to existing installations. Existing installations that have been installed in accordance with earlier editions of the Regulations may not comply with this edition in every respect. This does not necessarily mean that they are unsafe for continued use or require upgrading.
BS 7671:2008 includes changes necessary to maintain technical alignment with CENELEC harmonization documents. A summary of the main changes is given below.
You are correct but the regulations - which govern scheme members - do not allow for that.I feel there is a balance, the disruption should a RCD trip v the safety afforded by the RCD.
the RCD to the right is for the solar panels apparentlySimple answer is yes he is correct. There is nothing stopping you using what exists, but can't add.
The are ways, use of SWA cables, Alitube cables, and RCD sockets etc. but likely will cost more than a new consumer unit. But unit to the right does have a RCD, so why not use that one?
i asked if he could remove some plug sockets and install new onesWhich work can't he do without upgrading it?
do you have any idea how much a new CU with RCD costs?He is unable to make any changes to A circuit without bringing THAT CIRCUIT up to current regs. If he is only working on one circuit he may be able to transfer it to the second box.
But to be honest the difference in the amount of work involved upgrading one circuit and replacing what you have with a new Consumer Unit is normally not significant.
If by that you mean some sockets merely replacing existing ones then no alterations to the CU would be necessary.i asked if he could remove some plug sockets and install new ones.
What nonsense.Is an electric cooker safe if not RCD protected? I thought that they were considered pretty much like electric showers - potentially lethal without an RCD.
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local