Ive got a leak

Joined
11 Jun 2024
Messages
42
Reaction score
1
Country
United Kingdom
Hi all . I have a leak in the roof for my extension. It's not every time it rains , and it's only done it twice since November/December. Damp patches are only visible in 2 areas one in a top corner of the hole for the velux . And another toward the bottom of the roof where a profile is for a L.E.D strip. Any suggestion on how to locate where water is getting in?

2 pics included. the red is roughly where the 2nd damp patch usually is. Its dried since seing it this morning
 

Attachments

  • 20250105_233216.jpg
    20250105_233216.jpg
    146.1 KB · Views: 44
  • 20250105_233259.jpg
    20250105_233259.jpg
    157.1 KB · Views: 44
Sponsored Links
I'll try a get a picture of the outside the the velux in the morning.

Also is there a way of taking the window out so I can check if there is anything blocking the water from draining properly
 
I'll try a get a picture of the outside the the velux in the morning.

Also is there a way of taking the window out so I can check if there is anything blocking the water from draining properly
You'll need to photo all the way up to the abutment. The Velux is interrupting the water, so it may be a leak further up. We make a rain deflector at the top of our roof windows in the event of a leak above.

EDIT: is yours a flattie with a curb upstand?
 
The velux is flat on the roof. Any pics of your rain deflector? It's bizarre it's doesn't do it every time it rains. It's rained plenty of times since we've been here but only seen this twice.

To dark to get a picture this morning unfortunately
 
Sponsored Links
Also is there a way of taking the window out so I can check if there is anything blocking the water from draining properly

If the Velux is the usual tilt and turn type, which can be rotated almost 180 degrees, then there are catches at either side of the hinge mechanism, to release it and allow window and frame to be released, and removed. The catches, are like a peg, which simply tap level with the hinge, to release. Basically - rotate the window 180 degrees, then using a small hammer, tap the pins at each side. Window can then be slid off the hinges, but they are very heavy, it will need two strong people.

Refitting, is a matter of engaging both sides, back in the hinges, then rotating back to closed position. The pins automatically return to their default locked position.
 
If the Velux is the usual tilt and turn type, which can be rotated almost 180 degrees, then there are catches at either side of the hinge mechanism, to release it and allow window and frame to be released, and removed.
The 'sash' can be removed - not the frame!

There is not much to be gained by removing the sash.
 
Last thing I want is to go on the roof . I'm not the lightest person. I was hoping to pop my head out the velux. It's flat on the roof but not a flat roof it a lean too but 4m long and 3.8m wide
 
**** dark picture but tye best can do at tye moment. Does show some moss build up
 

Attachments

  • 20250106_181625.jpg
    20250106_181625.jpg
    290.2 KB · Views: 18

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top