Plaster fell off the ceiling

Joined
5 Dec 2010
Messages
73
Reaction score
2
Country
United Kingdom
20250314_174911.jpg



I have a roughly 4.5 foot by 1.5 foot area of lath and plaster that fell off an edge of my ceiling.Can I patch it ?

It is not very strong but one length does meet/follow the wall,which should make it that bit more manageble.
20250314_175216.jpg
20250314_174911.jpg


20250314_174838.jpg
 
Sponsored Links
Got any Y shaped cracked in ceiling? That's a bad sign.
Ceiling needs overboarding and skim.
Hire board lifter for a week and plasterboard over with 50mm drywall screws.
I don't recommend patching.

To patch brush some Sbr around edges and blob sone plaster around to firm up before more falls.
Cut plasterboard to fit and fix
Bonding and skim.
I wouldn't though.

Although you can do this.

 
Got any Y shaped cracked in ceiling? That's a bad sign.
Ceiling needs overboarding and skim.
Hire board lifter for a week and plasterboard over with 50mm drywall screws.
I don't recommend patching.

To patch brush some Sbr around edges and blob sone plaster around to firm up before more falls.
Cut plasterboard to fit and fix
Bonding and skim.
I wouldn't though.

Although you can do this.

Thanks.Would it be safe in the short term to just paint over the area with thick paint like artec(think that is what t it is called)?

I don't fancy taking up the carpet and floorboards just now.

Even some thin polystyrene sheet ? (that woud be a fire hazard but realistically that wouldn't concern me for a short time and for a small area)

I did an even smaller area elsewhere in the past by repairing the battens and applying plaster.(there had been a leak in the roof)

It was a pain in the arse and but I got it done.
 
Look like water staining around the edge of that hole. Have you had a water leak above, and has it been fixed?
 
Sponsored Links
Look like water staining around the edge of that hole. Have you had a water leak above, and has it been fixed?
You are right .It is worst at the wall's edge. Avery long term thing I think and the moisture levels in some of the battens ,whilst very low are not zero. (at the wall they are destroyed at the end )

Some years ago the water radiators that ran off the boiler were disconnected ( the main piping near the boiler burst and were not replaced) .

So I discount any recent leakage as being from that source since the radiators drained .even though they ae still in situ.

There is a window ledge directly above the damage (in the bedroom above) and that is my next job -To inspect the sill and close any gaps in the rendering (this is a very thick stone house.)

To get the whole ceiling done will be pretty expensive and disruptive (probably cannot afford it)

. I have it in mind (once I have sorted the leak source) of trying to repair the bad /missing battens and putting some kind of a finish on which is as flush as possible (I am no perfectionist)
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top