Sagged gate on metal posts

[mikeey84]

You can buy longer nozzles for resin tubes, as well as extension hose, however the rod will push a lot of the resin down, as long as the hole isn't much wider than it.

Just make sure you clean the hole as much as possible

 

[Harry Bloomfield]

Hadn't thought of using a nut then wood as a temporary way of get the post into exact position. Was just going to use a nut then cut off the remaining stud.

It might be worth your while, to pull the post back to the wall gradually, a little at a time over a week or two. That might avoid undue stress on the wall, or if the wall doesn't fail, bending the post.

 

[sofaman]

Right - no rush. Failing wall = bad.

Found some longer nozzles + extensions at 10mm. Read some data-sheets - for M8 resin anchors, 10mm hole is needed. I assume the same is the case for bog standard threaded rod.