Santon Unvented System - hot water to tundish

[da3533]

Hey Everyone,

This has been happening for time now. When ever the cylinder is fired, after around 10mins of boiling, the tundish is seen with water dripping frequently and later stops. After which, there is no further hot water from the taps.

When home, i will check the pressure on the vessel. As i can remember, the vessel should be 3bar with maximum of 6 bar pressure.

What sort of pressure should the vessel be when i check it?

Thanks

 

[da3533]

Hey Everyone,

This has been happening for time now. When ever the cylinder is fired, after around 10mins of boiling, the tundish is seen with water dripping frequently and later stops. After which, there is no further hot water from the taps.

When home, i will check the pressure on the vessel. As i can remember, the vessel should be 3bar with maximum of 6 bar pressure.

What sort of pressure should the vessel be when i check it?

Thanks

Just an update.. i doubt its the vessel, as the water in the tundish is not dripping, its flowing through.

 

[da3533]

I just checked the pressure and its 0 bar. nothing in it! is 3.5bar ok to fill/