What's the best way of finding the joist when securing the top plate of a stud wall to the ceiling? Thanks
Stud wall securing
- Thread starter tomsim
- Start date
Sponsored Links
Stud finder,or cheap version tap the ceiling
Measure in from the access hatch below and then from above.
Failing that, small masonry drill bit. It'll go through the plaster of the ceiling but not, the wooden joist. Try and repeat, until you hit something. Note, the ceiling pendant will likely be attached to a joist and then, 400mm (?) intervals away from this is a good starter.
Failing that, small masonry drill bit. It'll go through the plaster of the ceiling but not, the wooden joist. Try and repeat, until you hit something. Note, the ceiling pendant will likely be attached to a joist and then, 400mm (?) intervals away from this is a good starter.
Sponsored Links
Thanks then my timber uprights on the wall I should make at 400mm centres?
Mark up top plate and trim out the plasterboard so you can see all timbers .
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
