The gather corbelling is just where the chimney is going at an angle rather than vertically upwards. It’s taking the weight of the whole stack, all the way up. It probably goes vertically up after the ceiling of that room
Widening Chimney Opening
- Thread starter DIY_DIDDLER
- Start date
Sponsored Links
- Joined
- 22 Nov 2024
- Messages
- 8
- Reaction score
- 0
- Country
The diagram I did is based of measurements I did. The entire vertical is fully over the right hand side of breast - is this still likely to transfer load over to the left side?
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
