The 92.5° Grey Double Socket/Spigot 110mm Soil Pipe Branch allows the connection of horizontal pipes to vertical soil stack systems. The branch has two closed side bosses which when drilled out using a 50mm - 57mm hole cutter and boss adaptors are fitted...

The 110mm Anthracite Grey Short Soil Boss Pipe Socket/Spigot allows the connection of up to 3 separate waste pipes to the soil system. The boss pipe has one open and 2 closed bosses to use the open boss fit the appropriate adaptor which will allow a 32mm...

The 110mm Terracotta Back Inlet Gully Circular Lid has a 2nd inlet and is generally used in the middle of a pipe run such as a line of drainage on a patio. In these situations the gully should only be used for stormwater or rainwater and not foul drainage.The...

The 92.5° Grey Socket/Spigot 110mm Soil Pipe Bend is used for changing the direction of 110mm soil pipe systems. This push-fit bend has a spigot at 1 end which should always form the lower joint and a socket at the other end.

The 0° to 90° Anthracite Grey Double Socket 110mm Soil Pipe Adjustable Bend has a double socket and allows you to adjust the bend angle from 0° to 90° to suit a situation when a standard fixed angle bend will not form the desired angle.

The Black 300mm Drain Leaf Guard is designed to prevent leaves and debris entering drain gullies and blocking up your drains. Suitable for 65mm square line or 68mm round line rainwater downpipes. The guard is supplied with cutting guides to assist installation...

The 15° Terracotta Socket/Spigot 110mm Underground Drainage Bend is used for changing the direction of 110mm underground drainage systems. This push-fit bend has a spigot at one end which should be installed in the direction of flow within the system.

The 110mm Anthracite Grey Double Socket Coupling is used to form a push-fit joint between 2 lengths of 110mm soil pipes. This product can also be used as a slip coupling by simply removing the centre stops in the middle of the product.

The 110mm Terracotta Square Drain Inlet Hopper is generally used in conjunction with the universal gully trap 432053 as an inlet. The hopper head is connected to the gully using the underground drainage pipe which can be cut to length so that the hopper...

Rainwater harvesting works by taking the rain from roofs and filtering out leaves and debris before storing the water underground in the main storage tank. The water is then pumped into the property to be used for non-drinking applications e.g. flushing...