For biscuit jointing of timber, man-made fibre and particle board with the router. D 40 mm C 4 mm B 15 mm B2 19 mm B3 23 mm Shank Diameter 1/2 inch

Machining of traditional panels and frame doors, formerly done on spindle moulders, can now be performed with heavy duty routers mounted in fixed positions, either overhead or inverted. These Raised Panel cutters run best at lower speeds and match our...

Recessing cutter will accommodate the Schlegel Aquamac 21 or Exitex Aquatex A10 seal. D 46.3 mm D2 34.3 mm C 10.3 mm C2 2.7 mm OL 90 mm B 28.6 mm

Machining of traditional panels and frame doors, formerly done on spindle moulders, can now be performed with heavy duty routers mounted in fixed positions, either overhead or inverted. These Raised Panel cutters run best at lower speeds and match our...

Self-guiding cutters for rounding over edges do not require a side fence. D 32 mm C 16 mm B 9.5 mm B2 12.7 mm R 9.5 mm

TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. D 3/4 inch D 19.1 mm C 25 mm OL 67 mm

TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. All cutters above and including 9.5mm diameter, have TCT plunge centre tips. D 3 mm C 11 mm OL 51 mm

A one piece bearing guided set. Parts are inter-changed on the arbor to alter the set-up. D 41 mm C 6.35 mm C2 10 mm E 22 mm OL 76 mm Shank Diameter 1/2 inch Timber thickness min. 15 mm Timber thickness max. 22 mm

TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. D 63/64 inch D 25 mm C 25 mm OL 65 mm

These slotters have a 12mm clear bore to enable them to be mounted at any position on the arbor in combination with spacers, with or without a bearing. D 50 mm Bore 12 mm Kerf 5 mm No. of Teeth 4